How to install Allen Bradley PLCs- Part 2

How to install Allen Bradley PLCs

on my previous video I show you how to install and configure an Allen Bradley flex io module.

now i’m going to show you how to do a wiring configuration on an Allen Bradley flex io mode use.

so of course you need to supply your communication module,

the comb here will be the negative and plus twenty four will be the positive and make sure you also connect a 24 volts to your terminal bus module

here the cone will be the negative and the v is for the positive and that applies also on the other modules com and b.

so for the profivus connector

communication cable

so you am using standard shipmans and profit bus

connected to your plc

so i’m using AL shimens blc

and my iOS so here my push button and your stop and start for example

so the wire inputs and outputs all you have to do is to me a connection which is i will draw

so they be like this

so just in case this is your push button

and here is your Module i/o

here you have here twenty four

plus twenty four connected for example to number eight

so you need to send up plus twenty four

to number eight terminal to your terminal bus module

once you do that

by pressing the start

to send signal

to your io module

as easy as that